Look at the moving map on almost any airliner seatback screen and the altitude will settle somewhere in the 30,000s. Outside, the air is roughly minus 50 degrees Celsius and only about a third as dense as at sea level. Nobody could survive there for long without a pressurised cabin. So why do airliners cruise up there at all, after burning so much fuel to climb?
The short answer is fuel. Cruise is where an airliner burns most of its fuel, and the thin, cold air of the upper troposphere is where a jet turns that fuel into distance most efficiently. The long answer involves drag, engine physics, the weight of the aircraft, the wind, air traffic rules and the limits of the wing itself.
Quick Facts
- Typical airliner cruise: About 31,000 to 38,000 ft
- Standard tropopause: 11,000 m (36,089 ft), minus 56.5 °C in the International Standard Atmosphere
- Air density at 11 km: About 0.36 kg/m³, under a third of sea level
- Typical cruise speeds: About Mach 0.78 (A320, 737NG); about Mach 0.85 (A350, 787)
- Step climbs: Usually 1,000, 2,000 or 4,000 ft, with ATC clearance
- RVSM: 1,000 ft separation from FL290 to FL410 (previously 2,000 ft above FL290)
- Cabin rule (14 CFR 25.841): Cabin pressure altitude no more than 8,000 ft in normal operation
Thin air, more miles per kilo
Fly higher and the air gets thinner. At the 11,000-metre (36,089-foot) boundary of the standard atmosphere, density is about 0.36 kg per cubic metre, compared with 1.225 at sea level. Thinner air produces less drag at a given speed, but it also produces less lift, so the aircraft must fly faster through it to hold itself up.
Here is the aha moment. A jet flying at its most efficient angle of attack makes roughly the same drag whether it is low or high. But up high, it is moving much faster over the ground for that same drag. Since a jet engine’s fuel flow tracks the thrust it must produce, the same fuel buys more miles. The FAA’s handbooks describe the same trade from the other side: as altitude rises, true airspeed rises for the same drag.
Then comes the bonus. Temperature falls steadily as you climb through the troposphere, by about 6.5 degrees Celsius per kilometre in the standard atmosphere, and jet engines love cold air.
Why around 35,000 feet in particular?
The temperature keeps falling only up to the tropopause, the lid of the troposphere. In the International Standard Atmosphere it sits at 11,000 metres, or 36,089 feet, where the temperature has fallen to minus 56.5 degrees Celsius; NASA’s atmosphere model puts it at 36,152 feet. Above that, the air stops getting colder, so the engine-efficiency bonus stops growing while the air keeps thinning.

That is a big part of why typical airliner cruise altitudes cluster between 31,000 and 38,000 feet, right around the tropopause in mid-latitudes. The real tropopause moves, of course: it is about 17 km high over the equator and about 9 km over the poles. Being near it has another benefit. The troposphere below is the layer in which most weather happens, so cruising near its top keeps airliners above much of the bumpy, wet stuff.
Speed is part of the package. Common narrowbodies such as the Airbus A320 and Boeing 737NG typically cruise at about Mach 0.78, and widebodies such as the Airbus A350 and Boeing 787 at about Mach 0.85.
Mentour Pilot explains what happens when an airliner climbs too high.
Why not just keep climbing?
Because the gains run out. Jet engines lose thrust as the air thins, and the FAA’s Airplane Flying Handbook warns that at high altitude engines may be running close to their rpm or temperature limits, with little excess thrust left over. An airliner that climbs too high may be able to stay up but not to accelerate, climb or manoeuvre well.
The wing has limits too. As the air thins, the speed at which the wing stalls rises, while the speed at which shock waves cause Mach buffet stays put or falls. Eventually the two meet in the so-called coffin corner, a narrow band where too slow and too fast are only a few knots apart. Airlines keep well clear of it.
Heavy jets fly lower: the step climb
There is no single best altitude, because the aircraft keeps changing. At the start of a long flight it is full of fuel and at its heaviest. A heavy aircraft needs more lift, which it can only get efficiently in denser air, so its optimum altitude is lower. As fuel burns off, the aircraft gets lighter and its optimum altitude rises. The FAA’s Pilot’s Handbook of Aeronautical Knowledge spells it out: as gross weight decreases, the optimum altitude may increase.
In an empty sky, the ideal would be a slow, continuous cruise climb. Concorde did exactly that, with its altitude band near 60,000 feet almost to itself. Airliners share their airspace, though, so they climb in steps instead, usually of 1,000, 2,000 or 4,000 feet depending on the flight-level rules, each one cleared by air traffic control.

The flight management computer works out where each step should come. A long-haul flight may therefore start in the low or mid 30s and finish several thousand feet higher. Wind matters too: a strong headwind at the theoretical best level can make a slightly lower or higher level cheaper on the day, which is why pilots and dispatchers look at winds as well as weight.
How step climbs are planned and flown in the Airbus A320, from the cruise performance pages of the flight management computer.
RVSM: more lanes at the right height
The ideal altitude band is also the busiest. Until the arrival of Reduced Vertical Separation Minimum, or RVSM, aircraft above flight level 290 had to be separated by 2,000 feet. RVSM cut that to 1,000 feet between FL290 and FL410, almost doubling the number of usable levels in exactly the band airliners want.
Europe introduced RVSM between 1997 and 2005, and the whole western hemisphere adopted it on 20 January 2005. More levels means more aircraft can fly at or near their optimum altitude, instead of being parked lower and burning extra fuel. We explained the flight-level system itself in our guide to flight levels and transition altitude.
What 1,000-foot RVSM separation looks like from the cabin when another airliner passes above or below.
The cabin pays the bill
Cruising high has a cost: the higher you go, the bigger the pressure difference the fuselage must hold. US certification rules require the cabin to be kept at a pressure altitude of no more than 8,000 feet in normal operation, however high the aircraft flies. Newer designs aim for lower cabin altitudes, as we explained in why cabins are pressurised to 6,000 feet, not sea level.
So 35,000 feet is not a magic number. It is a compromise that falls out of physics: high enough for thin air and cold, efficient engines, low enough for the engines and wing to keep a healthy margin, near the top of the weather, and in the band where air traffic control can now stack the most aircraft. Next time the map says 37,000 feet, that is fuel being saved.
Sources: FAA Airplane Flying Handbook (FAA-H-8083-3C), FAA Pilot’s Handbook of Aeronautical Knowledge (Chapter 11), FAA (RVSM), 14 CFR 25.841 (eCFR), Boeing AERO magazine, NASA Glenn Research Center (Earth Atmosphere Model), NASA Armstrong, Wikipedia (Cruise; Step climb; International Standard Atmosphere; Tropopause; Reduced vertical separation minima)
Header photo: NASA / Jim Ross, public domain




0 Comments