Muret, a small town south of Toulouse, is where Clément Ader was born, the French engineer whose steam-powered Éole hopped off the ground in 1890. On Thursday 19 November 2026, the town’s airfield hosted another French attempt at a new kind of flying machine.
Toulouse start-up Ascendance rolled out the first full-scale prototype of ATEA, its hybrid-electric vertical take-off and landing aircraft. The dark, compact machine on the apron at Muret-Lherm is the result of eight years of work and, by the company’s count, €60 million of investment.
It is not flying yet. But it is real, it is full size, and it is the clearest sign so far that Europe has a serious hybrid VTOL contender of its own.
Quick Facts
- Aircraft: Ascendance ATEA, hybrid-electric VTOL
- Unveiled: Thursday 19 November 2026, Muret-Lherm airfield near Toulouse
- Lift and thrust: Eight electric rotors in the wings; two propellers for cruise (nose and tail)
- Propulsion: STERNA hybrid-electric system; Safran ENGINeUS electric motors
- Seats and range: Reported as 1 pilot + 4 passengers and up to 400 km (AeroTime); 4 to 6 seats and up to 900 km (AFP)
- Investment: €60 million over eight years, according to the company
- First flight: Planned for 2027, after ground tests and an EASA permit to fly
Eight rotors, two propellers, two kinds of power
ATEA is designed to take off like a helicopter and cruise like an aeroplane. According to AeroTime, eight electric rotors embedded in its wings handle vertical take-off and landing, while two propellers, one in the nose and one at the back of the tail, push it in forward flight. AFP describes the layout as two pairs of wings carrying the eight rotors.
The power comes from STERNA, Ascendance’s in-house hybrid-electric system. Batteries supply the surge needed for take-off and landing, and fuel-burning generators take over in cruise, running on Jet A-1 or sustainable aviation fuel. CEO and co-founder Jean-Christophe Lambert describes ATEA as doublement hybride, doubly hybrid, because it mixes two flight modes and two energy sources. In March 2025 the company picked Safran’s ENGINeUS electric motor for the flying prototype.

The airframe was built by Duqueine Group in Lyon under Ascendance’s direction, and its completion was announced in February 2026. Since then the team has been fitting propulsion, avionics and fly-by-wire controls.
What it is meant to do, and how far
Ascendance pitches ATEA as an alternative to the helicopter for medical transport, passenger shuttles, logistics, surveillance and defence work. AFP reports that the company also highlights a low noise level, and stealthiness for military applications.
Published performance figures vary between reports. AeroTime gives one pilot plus four passengers and a range of up to 400 kilometres, including a 30-minute reserve. AFP and Le Journal de l’Aviation quote four to six seats and up to 900 kilometres, and Le Journal de l’Aviation adds a speed of 250 km/h. Until the aircraft flies, all of them are targets rather than results.
First flight in 2027, after a long ground campaign
Lambert was careful not to over-promise at Muret. Rolling out the prototype, he told AFP, does not necessarily mean it will fly tomorrow: ATEA faces four to five months of ground testing of every system, then low-speed taxi runs, then a permit to fly from EASA for high-speed taxiing, and only then a first flight. AFP puts that at around the end of the first quarter of 2027; FlightGlobal reports a target of mid-2027.
The caution is earned. When Ascendance revealed the ATEA design in December 2021, Lambert said a full-scale prototype would be testing by 2023. After first flight, AFP reports, the company expects 18 to 24 months of flight testing before any move towards production.
Safran’s video on its ENGINeUS electric motor, the motor Ascendance selected for the ATEA prototype.
Co-founder Clément Dinel, who leads propulsion and hybridisation, told AFP the propulsion system has been fully validated on test benches. What remains is to prove it on the aircraft itself, with real wind, vibration and acceleration. By February 2026, STERNA had logged more than 500 hours of bench testing, according to the company.
A European bet, on a European budget
Lambert used the roll-out to make a political point. ATEA, he said, is built mostly from European components, and Europe needs to strengthen its industrial autonomy in aerospace. He also admitted that €60 million is small change next to what American and Chinese eVTOL developers have raised; according to L’Aéro Recrute, he put the cost of launching production at €500 million to €1 billion.
The order book is made of intentions. AFP reports more than 630 letters of intent for ATEA. STERNA has its own life beyond the aircraft: in July 2026 Ascendance signed a letter of intent with ATR to study hybrid-electric propulsion for future regional aircraft, and on 4 November it signed a memorandum of understanding with Naval Group at Euronaval.
Clément Ader’s Éole managed a short hop and little more. ATEA’s builders are aiming considerably higher. In 2027, Muret will find out how high.
Sources: AFP (via Connaissance des Énergies), AeroTime, Le Journal de l’Aviation, FlightGlobal, FLYING Magazine, L’Aéro Recrute
Header photo: Ascendance (press image)




0 Comments