
Temperatures of the SR-71 during flight (550\u00b0F ~290\u00b0C).<\/p><\/div>\n
also caused corrosion, requiring entirely new tools to be procured. There were also problems with metallurgical contamination at one point during Blackbird production, over 80% of delivered titanium had to be discarded. Interesting note here:\u00a0The primary alloy for the SR-71, titanium, was so scarce outside the USSR that the CIA had to import some covertly from the Soviet Union.\nOne might assume this aircraft was at its structural limits at Mach 3, but in fact, it performs best at this speed. As a matter of fact, it was built to fly at this speed. At very high speeds of Mach 3+, the SR-71 flight body heats up so much that the metal expands a lot. If the metal pieces of the airplane at this point would have been tightly screwed together, the aircraft would simply expand to its own death, making the expansion push the metal pieces into each other with very<\/i> serious consequences. This is why the\u00a0Lockheed Skunk Works division\u00a0built the Blackbird with big gaps at some points in the structure, resulting in the body dripping fuel, as is explained by the quote below:<\/p>\n\n\n\u201cIronically, the plane was dripping, [...] Fuel was seeping through the joints, raining down on the hangar floor. At Mach 3, the plane would expand several inches because of the severe temperature, which could heat the leading edge of the wing to 1,100 degrees. To prevent cracking, expansion joints had been built into the plane. Sealant resembling rubber glue covered the seams, but when the plane was subsonic, fuel would leak through the joints.\u201d <\/i>- Major Brian Shul, Author of \u201cSled Driver\u201d.<\/i><\/p>\nhttps:\/\/youtu.be\/mHjhgeyhuKk<\/blockquote>\n